Editing Percentage attacks
Warning: You are not logged in.
Your IP address will be recorded in this page's edit history.The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | + | WarLight allows players to enter attacks as a percentage instead of raw army numbers. | |
− | + | Note that the percentage is applied to the total number of movable armies when the attack occurs. Therefore, if you want to split a stack equally between two attacks, you should first issue a 50% attack order and then a 100% attack order. | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
For example, say you have a stack of 41 armies and you issue a 50% attack order. One army must always stay behind, so 40 armies are movable. 50% of 40 is 20, so 20 armies will attack. | For example, say you have a stack of 41 armies and you issue a 50% attack order. One army must always stay behind, so 40 armies are movable. 50% of 40 is 20, so 20 armies will attack. | ||
Line 15: | Line 7: | ||
21 armies remain on the territory. If your second attack also says 50%, only 10 of the remaining 20 armies will attack. Entering 100% for the second attack causes an even split, 20 and 20. | 21 armies remain on the territory. If your second attack also says 50%, only 10 of the remaining 20 armies will attack. Entering 100% for the second attack causes an even split, 20 and 20. | ||
− | [[Category: | + | In [[multi-attack]] games, percentage attacks are the default. |
+ | |||
+ | [[Category:Gameplay]] |